USINGYOURWATERFILTER/CHILLER
1.Lift the hinged lid and using a suitable jug, carefully pour water into the tank up to the MAX FILL LEVEL. This may take some time due to the action of the filter.
2.Keep adding water until all the tanks are full. Water flows through the cartridge at a set rate. This is to achieve the best possible filtration. Because of this it may take some time to fill all the tanks on first use. During normal use top up the tanks regularly.
✎NOTE
After filling, it is important to vent any air in the unit otherwise the chiller will not function correctly. Do this by pressing the dispensing lever until the water flows from the dispenser without any air bubbles present. Once the water is clear of any air bubbles, the dispensing lever may be released. Top up the water tank if necessary.
3. Close the hinged lid.
4.Plug the unit into the mains supply. Press the chiller ON/OFF switch on the front of the unit. The switch will illuminate and the machine will begin to chill the water.
5.Dispense 2 litres of water from the unit to remove any unfiltered water from the unit that was used to prepare the chiller as instructed on page 4.
6.Within approximately 3 hours the blue indicator on the front of the unit will light indicating that the water has chilled to approximately 10OC, although this may take longer in very hot weather. The indicator will cycle on and off as the unit maintains its temperature, but the unit will continue to chill the water down to 8OC then stop. If the water temperature rises above 8OC the unit will start to chill again.
We recommend that the water chiller be kept out of direct sunlight and away from any heat source.
7.Place a glass under the dispenser and push the lever back to dispense water.
✎NOTE
It is normal for the indicator to go off when water is drawn. Water inside the unit will remain chilled but the indicator will not come on again until the optimum temperature has been reached.
8. Top up the water tank as necessary.
6
