![](/images/new-backgrounds/1060419/6041921x1.webp)
Operating your Breville ikon™ Microwave Oven
Installation | Setting the clock | |||
1. | Make sure that all the packing materials are | When power is activated, the LED will display | ||
| removed from the inside of the door. | ‘0:00 and the buzzer will beep once. | ||
2. | This microwave oven must be placed on a | 1. | Press ‘CLOCK’, the hour figures will flash. | |
| flat, stable surface to hold its weight and | 2. Turn dial to adjust the hour figures, the | ||
| the heaviest food likely to be cooked in the | |||
| oven. |
|
| input time should be within |
3. | Do not place the oven where heat, moisture | 3. | Press ‘CLOCK’, the minute figure will flash. | |
| or high humidity are generated, or near | 4. Turn dial to adjust the minutes figures, the | ||
| combustible materials. | |||
|
|
| input time should be within | |
|
|
|
| |
4. | For correct operation, the oven must have | 5. Press ‘CLOCK’ to finish clock setting. ‘:’ will | ||
| sufficient airflow. Allow 20cm of space | |||
|
|
| flash, and the time will illuminate. | |
| above the oven, 10cm at back and 5cm |
|
| |
|
|
|
| |
| at both sides. Do not cover or block any |
|
|
|
|
|
|
| |
| openings on the appliance. Do not remove |
|
| If the clock is not set, it will not function when |
| feet. This microwave oven must not be |
|
| powered. |
| placed in a cabinet. |
|
| During the process of clock setting, if you |
5. | Do not operate the oven without glass tray, |
|
| |
|
| press ‘STOP/CLEAR’, the oven will go back to | ||
| roller support, and shaft in their proper |
|
| the previous status automatically. |
| positions. |
|
|
|
6. |
|
| Note | |
Make sure that the power supply cord is |
|
| ||
|
|
| ||
|
|
|
undamaged and does not run under the oven or over any hot or sharp surface.
7.The power outlet must be readily accessible so that the oven can be easily unplugged in an emergency.
8.Do not use the oven outdoors
Assembling the glass turntable tray
1.Place the Roller Ring into position in the indented space in the oven cavity base.
2.Insert the Glass Turntable Tray into position, matching the indents on the base of the Turntable Tray with the indents in the shaft located in the centre of the oven cavity base.
WARNING: DO NOT IMMERSE THE MICROWAVE OVEN, POWER CORD OR PLUG IN WATER OR ANY OTHER LIQUID.
11
BMO200_IKON_MICROWAVE_V4.indd 11 | 4/7/08 11:50:01 | AM |
|
|
|