INSTALLATION
Continued
See chart below for minimum permanent flue opening you must provide. Attach damper clamp so the minimum permanent flue opening will be maintained at all times.
Chimney | Minimum Permanent |
Height (ft.) | Flue Opening (sq. in.) |
|
|
6' to 15' | 39 sq. inches |
15' to 30' | 29 sq. inches |
|
|
Area of Various Standard
Round Flues
Diameter (in.) | Area (sq. in.) |
5" | 20 sq. inches |
6" | 29 sq. inches |
7" | 39 sq. inches |
8" | 51 sq. inches |
|
|
INSTALLING HEATER BASE ASSEMBLY
CAUTION: Do not remove the data plates attached to the heater base assembly. The data plates contain important war- ranty and safety information.
WARNING: You must secure this heater to fireplace floor. If not, heater will move when you adjust controls. Moving heater may cause a gas leak.
WARNING: If installing in a sunken fireplace, special care is needed. You must raise the fire- place floor to allow access to heater control panel. This will in- sure adequate air flow and guard against sooting and controls be- ingdamaged.Raisefireplacefloor with noncombustible material. Make sure material is secure.
CAUTION: Do not pick up heater base assembly by the burner. This could damage heater. Only handle base assem- bly by grates.
IMPORTANT: Make sure the heater burners are level. If heater is not level, heater will not work properly. For thermostat models, avoid damage to thermostat bulb. Avoid nicks or sharp bends in thermostat bulb wire. Keep thermostat bulb in mounting bracket until ready to mount base to floor. See Optional Positioning Of Thermostat Sensing Bulb, pages 29 and 30.
Installation Items Needed
•hardware package (provided with heater)
•approved flexible gas hose (not provided) (if allowed by local codes)
•sealant resistant to propane (propane/LP) gas, not provided
•electric drill with 3/16" drill bit
•flathead screwdriver
1.Apply pipe joint sealant lightly to male threads of the fitting to be threaded into gas regulator. Connect approved flexible gas hose to gas regulator of heater (see Figure 12).
IMPORTANT: Hold gas regulator with wrench when connecting flexible gas hose.
2.Locate masonry screws in hardware package.
3.Position heater base assembly in fireplace.
4.Place logs in their proper position on heater base, see Installing Logs on pages 16 through 19.
5.Center heater base and logs
6.Carefully remove logs without moving heater base.
Flexible Gas Hose
(if allowed by local codes)
Heater Gas
Regulator
Fitting
Figure 12 - Attaching Flexible Gas Hose
to Heater Gas Regulator
12 | www.desatech.com |
