INSTALLATION
Continued
WARNING:Failuretoposition thepartsinaccordancewiththese diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
Dual Burner Biltmore Split Oak Models CCL3018PTA/NTA, CCL3924PTA/NTA, CCL3930PTB/NTB
Each log is marked with a number. These num- bers will help you identify the log when install- ing. It is very important to install these logs ex- actly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place the front log (#1) on the grate fingers. Make sure the front log rests firmly between the grate fingers and the grate base (see Figure 24).
2.Place the base of the middle log (#2) in the U- shaped slots of the grate base. The cutout on the right of the middle log should fit over the burner (see Figure 25). Make sure the front of the middle log is resting on the tabs of the grate base.
3.Locate pins on the bottom of back log (#3). Slide these pins into the holes in the grate base behind the burner (see Figure 26).
4.Locate holes on the bottom of crossover log (#4). Slide front hole onto the left pin (CCL3924PTA/NTA or CCL3930PTB/NTB) or middle pin (CCL3018PA/NA or CCL3018PTA/NTA) on the middle log (#2) and the pin on the back log (#3). See Figure 27 for placement.
Front
Log (#1)
Grate
Fingers
Middle
Log (#2)
Burner
Tab | |
|
Figure 25 - Installing Middle Log #2
(CCL3930PTB/NTB Shown)
Pins
Rear
Log (#3)
Hole in
Grate Base
Burner
Figure 26 - Installing Rear Log #3
(CCL3930PTB/NTB Shown)
| Crossover | |
| Log (#4) | |
Middle | Pins | |
Back Log | ||
Log (#2) | ||
(#3) | ||
|
Figure 27 - Installing Crossover Log #4
(CCL3930PTB/NTB Shown)
Grate
Base
Figure 24 - Installing Front Log #1
(CCL3930PTB/NTB Shown)
www.desatech.com | 17 |
