OPTIONAL POSITIONING
OF THERMOSTAT
SENSING BULB
Continued
4.The mounting clip must be a minimum of 3" from bottom of fireplace to prevent crimping of capillary. Once you have decided on a lo- cation, clean the area thoroughly. Remove the paper backing from the adhesive on back of mounting clip. Press the clip into the new lo- cation so that the thermostat sensing bulb will be positioned vertically with the capillary at the bottom (see Figure 49). Slide the thermo- stat sensing bulb into the clip.
IMPORTANT: Do not crimp capillary.
Thermostat
Sensing Bulb
Mounting Clip
Capillary
Do Not Crimp
Capillary
Figure 49 - Positioning the Thermostat Sensing Bulb in the Vertical Position with the Capillary at the Bottom
REPLACEMENT PARTS
Note: Use only original replacement parts. This will protect your warranty coverage for parts re- placed under warranty.
PARTS UNDER WARRANTY
Contact authorized dealers of this product. If they can’t supply original replacement part(s), contact your nearest Parts Central (see page 42) or call DESA Heating Products’Technical Service Department at
When calling DESA Heating Products, have ready
•your name
•your address
•model and serial numbers of your heater
•how heater was malfunctioning
•type of gas used (propane/LP or natural gas)
•purchase date
Usually, we will ask you to return the part to the factory.
PARTS NOT UNDER WARRANTY
Contact authorized dealers of this product. If they can’t supply original replacement part(s), contact your near- est Parts Central (see page 42) or call DESA Heating Products at
•model number of your heater
•the replacement part number
30 | www.desatech.com |
