Desa CRL2718P/N, CRL3124P/N, CGD3018PT/NT Safety Information, Product Identification, Continued

SAFETY INFORMATION

Continued

4.If you smell gas

•shut off gas supply

•do not try to light any appliance

•do not touch any electrical switch; do not use any phone in your building

•immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions

•if you cannot reach your gas supplier, call the fire department

5.This heater shall not be installed in a bedroom or bathroom unless installed as a vented ap- pliance (Variable Manually-Controlled Mod- els Only) (see Installing Damper Clamp Ac- cessory for Vented Operation, page 11).

6.Before installing in a solid fuel burning fireplace, the chimney flue and firebox must be cleaned of soot, creosote, ashes and loose paint by a quali- fied chimney cleaner. Creosote will ignite if highly heated. A dirty chimney flue may cre- ate and distribute soot within the house. In- spect chimney flue for damage. If damaged, repair flue and firebox before operating heater.

7.Do not burn solid-fuel in a masonry or UL127 factory-built fireplace in which a vent-free room heater is installed.

8.If fireplace has glass doors, never operate this heater with glass doors closed. If you operate heater with doors closed, heat buildup inside fire- place will cause glass to burst. Make sure there are no obstructions across openings of fireplace.

9.This log heater is designed to be smokeless. If logs ever appear to smoke, turn off heater and call a qualified service person. Note: During initial operation, slight smoking could occur due to log curing and heater burning manufacturing residues.

10.To prevent the creation of soot, follow the in- structions in Cleaning and Maintenance, pages 24 and 25.

11.Before using furniture polish, wax, carpet cleaner, or similar products, turn heater off. If heated, the vapors from these products may create a white powder residue within burner box or on adjacent walls or furniture.

12.This heater needs fresh, outside air ventila- tion to run properly. This heater has an Oxy- gen Depletion Sensing (ODS) safety shutoff system. The ODS shuts down the heater if not enough fresh air is available. See Air for Com- bustion and Ventilation, pages 5 through 7. If heater keeps shutting off, see Troubleshoot- ing, pages 26 through 28.

13.Do not run heater

•where flammable liquids or vapors are used or stored

•under dusty conditions

14.Do not use this heater to cook food or burn paper or other objects.

15.Do not use heater if any part has been exposed to or under water. Immediately call a qualified service technician to inspect the room heater and to replace any part of the control system and any gas control which has been under water.

16.Do not operate heater if any log is broken. Do not operate heater if a log is chipped (dime- sized or larger).

17.Turn heater off and let cool before servicing. Only a qualified service person should ser- vice and repair heater.

18.Operating heater above elevations of 4,500 feet could cause pilot outage.

19.Provide adequate clearances around air openings.

PRODUCT

IDENTIFICATION

Crossover Log	Back Log
Front	Middle Log
Log

Piezo
Ignitor	Burner

Control Base

Knob Grate

Figure 1 - Vent-Free Gas Log Heater - Dual Burner (Logs May Vary by Model - Smoky Mountain Oak Model Shown)

Crossover Log

Front Log Back Log

Burner

Piezo

Ignitor

Control Knob

Figure 2 - Vent-Free Gas Log Heater - Single Burner (Logs May Vary by Model - Seasonal Oak Model Shown)

4 www.desatech.com 111160-01C