900W Generator
NOTE: If engine starts after 3 pulls, but fails to run for more than 10 seconds, check for proper oil level in crankcase. This unit is equipped with a Oil Alert System (see page 8).
•Slide the choke lever left to the “Run” position as the engine warms up.
NOTE: Under no load conditions, the engine speed may vary slightly faster or slower until engine temperatures stabilize.
Oil Alert System
The Oil Alert System is designed to prevent engine damage caused by an insufficient amount of oil in the crankcase. Before the oil level in the crankcase can fall below a safe limit, the Oil Alert System will automatically shut down the engine (the engine switch will remain in the “On” position).
If the Oil Alert System shuts down the engine, add engine oil.
CAUTION! Breathing Hazard! NEVER run engine in enclosed poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas.
Connecting Electrical Loads
•Let engine stabilize and warm up for a few minutes after starting.
•DO NOT connect 240 Volt loads to 120 Volt receptacles.
•DO NOT connect
•DO NOT connect 50 Hz loads to the generator.
•Plug in and turn on the desired 120 Volt AC, single phase, 60 Hertz electrical loads.
•DO NOT OVERLOAD THE GENERATOR. Add up the rated watts (or amps) of all loads to be connected at one time. This total should not be greater than the rated wattage/amperage capacity of the generator. See “Don’t Overload the Generator” on page 10.
Stopping the Engine
•Unplug all electrical loads from the unit. NEVER start or stop engine with electrical devices plugged in and turned on.
•Let engine run at
•Move engine switch to the “Off” position.
•Turn the fuel valve to the “Close” position (fully counterclockwise).
NOTE: In an emergency, stop the engine by moving the engine switch to the “Off” position.
Charging a Battery
WARNING! Storage batteries emit explosive gas while charging that remains around a battery for a long time after it has been charged. The slightest spark can ignite the gas, causing an explosion that can shatter the battery and cause blindness or other injury.
WARNING! DO NOT permit smoking, open flame, sparks or any other source of heat around a battery. DO NOT use a lighter or other flame for checking battery fluid levels. Wear protective goggles, rubber apron and rubber gloves when working around a battery. Battery electrolyte fluid is an extremely caustic sulfuric acid solution that can cause severe burns. DO NOT permit fluid contact with eyes, skin, clothing, etc. If spill occurs, flush area with clear water immediately.
Your generator has the capability of recharging a discharged 12 Volt automotive or utility style storage battery. DO NOT use the unit to charge any 6 Volt batteries. DO NOT use the unit to crank an engine having a discharged battery.
To recharge 12 Volt batteries, proceed as follows:
•If necessary, clean battery posts or terminals.
•Check fluid level in all battery cells. If necessary, add ONLY distilled water to cover separators in battery cells. DO NOT use tap water.
•If the battery is equipped with vent caps, make sure they are installed and are tight.
•Connect battery charge cable connector plug to the 12 Volt DC panel receptacle.
•Connect battery charge cable clamp with red handle to battery post or terminal indicated by Positive, POS or (+) (Figure 7).
8
