ASSEMBLY
ASSEMBLY
Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your generator, please call the generator helpline at
Unpacking the Generator
1.Set the carton on a rigid flat surface.
2.Remove everything from carton except generator.
3.Open carton completely by cutting each corner from top to bottom.
4.Leave generator on carton to install handle.
Carton Contents
Check all contents against those listed below:
•Main unit
•Handle
•Locking 30 Amp plug
•Engine oil
•Two packets of fuel stabilizer
•Handle attachment hardware
•Operator’s manual
•Engine operator’s manual
If any parts are missing or damaged, call the generator helpline at
Attach Handle to Unit
1.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 1).
Figure 1 — Attach Handle to Base
Handle
Align Holes
Handle
Supports
NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.
2.Insert carriage bolts through holes from outside of the unit and attach a plastic knob from inside of unit (Figure 2).Tighten by hand.
Figure 2 — Secure Handle
6