TROUBLESHOOTING
TROUBLESHOOTING
Problem | Cause | Solution | |||
| 1. | Circuit breaker is open. | 1. | Reset circuit breaker. | |
| 2. | Poor connection or defective cord | 2. | Check and repair. | |
Generator is running, but no AC |
| set. |
|
| |
output is available. | 3. | Connected device is bad. | 3. | Connect another device that is in | |
|
|
|
| good condition. | |
| 4. | Fault in generator. | 4. | Contact authorized service facility. | |
|
|
|
|
| |
Generator runs good but bogs | 1. | Short circuit in a connected load. | 1. | Disconnect shorted electrical load. | |
2. | Generator is overloaded. | 2. | See "Don't Overload Generator". | ||
down when loads are connected. | |||||
3. | Shorted generator circuit. | 3. | Contact authorized service facility. | ||
| |||||
|
|
|
|
| |
| 1. | Fuel valve is in the "Off" position. | 1. | Turn fuel valve to the "On" | |
Generator will not start; or starts |
|
|
| position. | |
2. | Vent knob in fuel gauge is closed. | 2. | Open vent knob in fuel gauge. | ||
and runs rough. | |||||
3. | Low oil level. | 3. | Fill crankcase to proper level or | ||
| |||||
|
|
|
| place generator on level surface. | |
|
|
|
|
| |
Generator shuts down during | 1. | Out of fuel. | 1. | Fill fuel tank. | |
2. | Low oil level. | 2. | Fill crankcase to proper level or | ||
operation. | |||||
|
|
| place generator on level surface. | ||
|
|
|
| ||
|
|
| |||
Generator lacks power. | Load is too high. | See "Don't Overload Generator". | |||
|
|
|
|
|
14