Briggs & Stratton 020238-0 operating instructions Install Wheel Kit, Add Engine Oil and Fuel

SpeedClean™ 2000 PSI Pressure Washer

Install Wheel Kit

The wheel kit is designed to greatly improve the portability of your pressure washer.

NOTE: Wheel kit is not intended for over-the-road use.

Refer to Figure 2 and install the wheel kit as follows:

1.Place the bottom of the pressure washer frame on a flat, even surface.Temporarily place unit on blocks to ease assembly.

2.Slide axle through holes in frame, as shown in Figure 2.

Figure 2 — Install Wheel Kit

3.Slide a wheel over the axle.

NOTE: Be sure to install wheel with raised hub inboard.

4.Retain wheel on axle stud with retaining pin.

5.Repeat step 3 and 4 to secure second wheel.

6.Remove the temporary blocks.

Add Engine Oil and Fuel

• Place pressure washer on a level surface.

CAUTION

Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.

•Refer to engine operator’s manual for oil and fuel fill information.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

•Refer to engine operator’s manual and follow oil and fuel recommendations and instructions.

NOTE: Check oil often during engine break–in. Refer to engine operator’s manual for recommendations.

8