Briggs & Stratton 030235-01 Service Air Cleaner, Service Spark Plug, Clean Spark Arrester Screen

Service Air Cleaner

Your engine will not run properly and may be damaged if you run it with a dirty air cleaner.

Replace the air cleaner every 25 hours of operation or once each year, whichever comes first. Replace more often if operating under dirty or dusty conditions.

To service the air cleaner, follow these steps:

1.Loosen screws (A) and remove air cleaner cover (B) (Figure 12).

D

C

B

A

Figure 12 — Service Air Cleaner

A - Screws

B - Air Cleaner Cover

C - Cartridge

D - Base

2.Carefully remove cartridge (C) from base (D).

3.Install clean (or new) air cleaner assembly inside cover. Dispose of old filter properly.

4.Assemble air cleaner cover onto base and tighten screws.

Service Spark Plug

Change the spark plug every 100 hours of operation or once each year, whichever comes first. This will help your engine to start easier and run better.

1.Clean area around spark plug.

2.Remove and inspect spark plug.

3.Check electrode gap with wire feeler gauge and reset spark plug gap to recommended gap if necessary (see Figure 13 and Specifications).

Figure 13 — Service Spark Plug

4.Replace spark plug if electrodes are pitted, burned or porcelain is cracked. Use the recommended replacement spark plug. See Specifications.

5.Install spark plug and tighten firmly.

Clean Spark Arrester Screen

The engine exhaust muffler has a spark arrester screen. Inspect and clean the screen every 100 hours of operation or once each year, whichever comes first.

If you use your generator on any forest-covered, brush- covered, or grass-covered unimproved land, it must have a spark arrester. The spark arrester must be maintained in good condition by the owner/operator.

15