Briggs & Stratton 1800 Removal, Normal Installation, Installation Instructions, Sub-Frame Hitch

Installation Instructions	Sub-Frame Hitch
C	Snowthrower
	Position
A	D
B
	E
	F
	A. Hitch Rod
	B. Hitch Rod
	C. Lift Lever Extension
	D. Lift Link (Manual)
	E. Pressure Lock Plate
	(Hydraulic)
	F. Hook

Figure 11. Normal Installation & Removal

REMOVAL NORMAL INSTALLATION

NOTE: After removing components, reinstall the clevis pins and clips to prevent loss.

1.Disconnect the lift rod from the attachment and lift lever extension (C, Figure 11).

2.Remove the clevis pin and clip from the lift lever (C) and remove the lift lever.

3.Remove the front hitch rod (A) and (B). Remove the hitch and hook (F).

4.Remove the lock plate (E) OR reposition the lift link

(D) in mowing position.

1.Insert the hook (F, Figure 11) into the back of the hitch. Mount the rear of the hitch on the lift cross- shaft.

2.Secure the front of the hitch to the J-hooks using the hitch rod (A) and (B) (Figure 8).

3.Install the downward pressure lock plate (E) OR place the lift link (D) in snowthrower position.

4.Install the lift lever extension (C).

5.Install the lift rod and attachment (Figure 10).

8