JVC DLA-RS40, DLA-RS60, DLA-RS50 manual Getting Started, English

PORTABLE CART WARNING (symbol provided by RETAC)

S3126A

ENGLISH

-All warnings on the product and in the operating instructions should be adhered to.

-All operating instructions should be followed.

-Place the projector near a wall outlet where the plug can be easily unplugged.

-Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

-Do not use attachments not recommended by the product manufacturer as they may be hazardous.

-Do not use this product near water. Do not use immediately after moving from a low temperature to high temperature, as this causes condensation, which may result in fire, electric shock, or other hazards.

-Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. The product should be mounted according to the manufacturer’s

instructions, and should use a mount recommend ed by the manufacturer.

- When the product is used on a cart, care should be taken to avoid

quick stops, excessive force, and uneven surfaces which may

cause the product and cart to overturn, damaging equipment or causing possible injury to the operator.

-Slots and openings in the cabinet are provided for ventilation. These ensure reliable operation of the product and protect it from overheating. These openings must not be blocked or covered. (The openings should never be blocked by placing the product on bed, sofa, rug, or similar surface. It should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided and the manufacturer’s instructions have been adhered to.)

-To allow better heat dissipation, keep a clearance between this unit and its surrounding as shown below. When this unit is enclosed in a space of dimensions as shown below, use an air-conditioner so that the internal and external temperatures are the same. Overheating can cause damage.

150 mm and above

-	power source indicated on the label. If you are
	not sure of the type of power supply to your
	home, consult your product dealer or local
	power company.
-	This product is equipped with a three-wire plug.
	This plug will fit only into a grounded power
	outlet. If you are unable to insert the plug into
	the outlet, contact your electrician to install the
	proper outlet. Do not defeat the safety purpose
	of the grounded plug.
-	Power-supply cords should be routed so that
	they are not likely to be walked on or pinched
	by items placed upon or against them. Pay
	particular attention to cords at doors, plugs,
	receptacles, and the point where they exit from
	the product.
-	For added protection of this product during a
	lightning storm, or when it is left unattended and
	unused for long periods of time, unplug it from
	the wall outlet and disconnect the cable system.
	This will prevent damage to the product due to
	lightning and power line surges.
-	Do not overload wall outlets, extension cords, or
	convenience receptacles on other equipment as
	this can result in a risk of fire or electric shock.
-	Never push objects of any kind into this product
	through openings as they may touch dangerous
	voltage points or short out parts that could result
	in a fire or electric shock. Never spill liquid of
	any kind on the product.
-	Do not attempt to service this product yourself
	as opening or removing covers may expose you
	to dangerous voltages and other hazards. Refer
	all service to qualified service personnel.
-	Unplug this product from the wall outlet and
	refer service to qualified service personnel
	under the following conditions:
	a)When the power supply cord or plug is damaged.
	b)If liquid has been spilled, or objects have fallen on
	the product.
	c)If the product has been exposed to rain or water.
	d)If the product does not operate normally by
	following the operating instructions. Adjust only
	those controls that are covered by the Operation
	Manual, as an improper adjustment of controls may
	result in damage and will often require extensive
	work by a qualified technician to restore the product
	to normal operation.

Getting Started

300 mm and above

150mm

and above

300 mm and above

200 mm and above

	e)If the product has been dropped or damaged in any
	way.
	f) When the product exhibits a distinct change in
	performance, this indicates a need for service.
-	When replacement parts are required, be sure
	the service technician has used replacement
	parts specified by the manufacturer or with
	same characteristics as the original part.
	Unauthorized substitutions may result in fire,
	electric shock, or other hazards.
-	Upon completion of any service or repairs to
	this product, ask the service technician to
	perform safety checks to determine that the
	product is in proper operating condition.

3