1 
Getting started
Controls and features (continued)
Main body - Input terminal
① HDMI 1 ② HDMI 2 ③ LAN RS50 RS506
⑤ COMPONENT
④
⑨ REMOTE
⑥ 3D SYNCHRO ⑦ PC ⑧ TRIGGER
RS50 RS506
①HDMI 1 Terminal
You can connect a device equipped with HDMI output, etc. It is fitted to the M3 lock hole. Screw hole depth 3mm. (Reference page: 26)
②HDMI 2 Terminal
⑥3D SYNCHRO terminal
3D synchro emitter: it is connected to the PK- EM1 (sold separately) when enjoying 3D video contents. (Reference page: 28)
⑦PC terminal “D-Sub 15 pin” RS50 RS506
You can connect a device equipped with HDMI output, etc. It is fitted to the M3 lock hole. Screw hole depth 3mm. (Reference page: 26)
This is an input term used for Personal Computer (PC) signals only (RGB video signals and sync signals). Use to connect a computer display output terminal, etc. (Reference page: 28)
③LAN terminal “RJ-45” RS50 RS506
This is a
④RS-232C terminal (male D-Sub 9
pin)
This is a
⑤COMPONENT terminal “RCAx3”
It is also used as input terminal for analog RGB (G on Sync) signals, component (Y, Cb, Cr) signals, DTV format (Y, Pb, Pr) signals. It can also be connected with devices, which are equipped with signal output, etc. (Reference page: 27)
⑧TRIGGER terminal( 
)
DC power supply output terminal with DC12V, 100mA. It is used for output signals which control the vacillating screen responding to the SCREEN TRIGGER. Please note it can cause damage
to your equipment if the connection is done incorrectly. (Tip = DC +12 V, Sleeve = GND) (Reference Page: 29, 54)
⑨REMOTE terminal to “Stereo mini
jack”
In case it is impossible to use the remote control due to the installation of this unit’s dedicated BOX or rear projection, one can set up an external light receiving section. It is used to connect this external receiver and this unit. There is no such product as an external light receptor. Therefore, please consult your authorized JVC service center. (Reference page: 30)
18
