JVC DLA-RS60 Sharpness, Custom Gamma, Adjustments and settings in the menu continued, Operation

ENGLISH

Adjustments and settings in the menu (continued)

Lamp Power It is possible to change the brightness of the lamp.

(*)If continually used with "High", the lamp will become dark earlier.

(*)The more one lets the interior temperature of the device rise due to generation of heat, the less the level of tolerance against high temperatures.

(*)For about 60 seconds after the lamp is lit, the lamp cannot be switched off.

	Settings: Normal, High	[Normal]
Normal	Normally this setting is chosen.(160W drive)
High	In a bright room, when the video is hard to see, this setting is chosen.(220W drive)

[1-2-1] Sharpness

Sharpness	Emphasizes the outlines of video images. Please adjust to your preference.
	Values: 0 to 50	(clear)
Detail Enhance	It makes minute details of the video images stand out. Please adjust to your preference.
	Values: 0 to 50	(strong)

[1-2-2] Custom Gamma

Custom 1~3	[1] It is possible to select a gamma curve adjustment for Custom 1, 2, and 3 under the
	"Gamma" of the picture adjust and then save it.
	Please adjust to your preference.

(*)Initial values of Custom 1, 2, and 3 are the same as for "Normal".

(*)Please refer to the figure at the bottom of the menu in two frames for adjustment.

(*)It is recommended that you read "Gamma Curve" (page reference: 56) for hints about adjustment.

Correction Value You can choose to add the underlying gamma curve adjustment.

(*)Can choose any setting, as the default gamma curve will always appear linear. Settings: Normal, A, B, C, D

(brightens in particular dark to intermediate parts) 1.8 to 2.6 (darkens in particular dark to

		intermediate parts) in the range of values with increments of 0.1	[Normal]
Gamma Adjustment		The gamma curve for "green" is being displayed as being representative. If "white", "red,"
		"green" or "blue" are selected, the corresponding color curves are displayed.
		Place the cursor on a gamma curve with 12 points with the buttons for left and right, and
		then use the buttons for up and down buttons to move those points up or down.
	White	Red, green and blue can be adjusted at the same time.
	Red	It is possible to adjust the gamma curve of red.
	Green	It is possible to adjust the gamma curve for green.
	Blue	It is possible to adjust the gamma curve for blue.
Reset		The same data as for the "Normal" mode are used.

(*)When you exit the adjustment menu of Custom Gamma, please save the adjustment values.

You can return to the original data, which should be saved.

(*)
Picture Adjust
>> Custom Gamma
Custom1	Correction Value			Normal
Custom2		White	1023
		Red
Custom3
		Green
				Gamma curve
		Blue	512
Gradation at the		Reset	0	Gradation diagram corresponding
				to the gamma curve.
selected point.
Exit		Operate Back
MENU Select				BACK

Operation

49