Snapper 2700 PSI Pressure Washer

TROUBLESHOOTING

Problem

Cause

Correction

 

1.

Low pressure nozzle installed.

1.

Replace nozzle with high pressure nozzle.

 

2.

Water inlet is blocked.

2.

Clear inlet.

Pump has following

3.

Inadequate water supply.

3.

Provide adequate water flow.

4.

Inlet hose is kinked or leaking.

4.

Straighten inlet hose, patch leak.

problems: failure to

5.

Clogged inlet hose strainer.

5.

Check and clean inlet hose strainer.

produce pressure, erratic

6.

Water supply is over 100°F.

6.

Provide cooler water supply.

pressure, chattering, loss of

7.

High pressure hose is blocked or

7.

Clear blocks in outlet hose.

pressure, low water

 

leaks.

 

 

volume.

 

 

 

8.

Gun leaks.

8.

Replace gun.

 

 

9.

Nozzle is obstructed.

9.

Clean nozzle.

 

10.

Pump is faulty.

10.

Contact Snapper service facility.

 

 

 

 

 

 

1.

Detergent siphoning tube is not

1.

Insert detergent siphoning tube into

 

 

submerged.

 

detergent.

Detergent fails to mix with

2.

Chemical filter is clogged.

2.

Clean or replace filter/detergent

spray.

 

 

 

siphoning tube.

 

3.

Dirty in-line filter.

3.

See “Check In-Line Filter” on page 12.

 

4.

High pressure nozzle installed.

4.

Replace nozzle with low pressure nozzle.

Engine runs good at no-

Engine speed is too slow.

Move throttle control to FAST position. If

load but “bogs” when load

 

 

engine still “bogs down”, contact Briggs and

is added.

 

 

Stratton service facility.

 

 

 

 

 

 

1.

Fuel valve is in the “Off” position.

1.

Turn fuel valve to the “On” position.

 

2.

Rocker switch is in the “Stop”

2.

Set the rocker switch to the “On”

 

 

position.

 

position.

 

3.

Dirty air cleaner.

3.

Clean or replace air cleaner.

 

4.

Out of gasoline.

4.

Fill fuel tank.

 

5.

Stale gasoline.

5.

Drain gas tank; fill with fresh fuel.

 

6.

Spark plug wire not connected to

6.

Connect wire to spark plug.

Engine will not start; or

 

spark plug.

 

 

7.

Bad spark plug.

7.

Replace spark plug.

starts and runs rough.

8.

Water in gasoline.

8.

Drain gas tank; fill with fresh fuel.

 

 

9.

Overchoking.

9.

Open choke fully and crank engine.

 

10.

Excessively rich fuel mixture.

10.

Contact Briggs and Stratton service

 

 

 

 

facility.

 

11.

Intake valve stuck open or closed.

11.

Contact Briggs and Stratton service

 

 

 

 

facility.

 

12.

Engine has lost compression.

12.

Contact Briggs and Stratton service

 

 

 

 

facility.

Engine shuts down during

Out of gasoline.

Fill fuel tank.

operation.

 

 

 

 

Engine lacks power.

Dirty air filter.

Replace air filter.

Engine “hunts” or falters.

Choke is opened too soon.

Move choke to halfway position until engine

 

 

 

runs smoothly.

 

 

 

 

 

15

Page 14 Page 16
Page 15
Image 15
Briggs & Stratton 2700PSI owner manual Troubleshooting
Page 14 Page 16

2700PSI specifications

The Briggs & Stratton 2700PSI pressure washer is an outstanding choice for both residential and light commercial cleaning tasks. Known for its robust design and powerful performance, this pressure washer delivers a maximum pressure of 2700 PSI and a water flow rate of 2.3 GPM, making it capable of tackling a wide range of cleaning jobs, from driveways to decks and patios.

A key feature of the Briggs & Stratton 2700PSI is its reliable engine. Powered by a Briggs & Stratton OHV engine, this pressure washer provides enhanced durability and efficiency. The engine operates smoothly and is designed for easy starting, thanks to its patented Ready Start technology, which eliminates the need for a primer bulb. Users can expect hassle-free operation, reducing the frustration often associated with starting gas-powered equipment.

In terms of versatility, the 2700PSI model offers five interchangeable nozzles, allowing users to adjust the spray pattern according to the specific cleaning task at hand. Ranging from a focused, high-pressure stream to a wide, gentle spray, these nozzles ensure that users can clean delicate surfaces without causing damage while still achieving superior cleaning performance on tough stains.

One of the standout features of this pressure washer is its onboard detergent tank. This built-in tank allows for easy application of soap, making it ideal for breaking down grime and dirt on heavily soiled surfaces. The pressure washer also includes a soap nozzle, optimizing soap application for effective cleaning results.

The Briggs & Stratton 2700PSI is designed with user convenience in mind. It comes equipped with a 25-foot high-pressure hose, providing ample reach for various cleaning tasks without the need to constantly move the machine. Additionally, its compact and lightweight design, along with sturdy wheels, enhances portability, making it easy to transport and store when not in use.

Safety features are also integrated into the design of this pressure washer. The total stop system automatically shuts off the pump when the trigger is not engaged, prolonging the lifespan of the motor and pump while conserving energy.

Overall, the Briggs & Stratton 2700PSI pressure washer stands out as a powerful and efficient cleaning solution. With its reliable engine, versatile nozzles, onboard detergent tank, and thoughtful safety features, it represents a great investment for anyone looking to maintain their outdoor spaces with ease and effectiveness. Whether washing vehicles, cleaning siding, or prepping surfaces for painting, this pressure washer is equipped to handle the job efficiently, making it a popular choice among homeowners and professionals alike.
Top Page Image Contents