Briggs & Stratton 2700PSI owner manual Add Engine Oil, Install Oil Dipstick on Pump, Add Gasoline

Snapper 2700 PSI Pressure Washer

Figure 2 — Secure Handle

•Insert the “L” bolt through the hole on the right side of the handle (viewing from rear of unit) and attach the plastic knob (Figure 2). Tighten the knob by hand. If not installed, add the vinyl cap to the “L” bolt.

•Insert the multi–colored nozzles in the spaces provided in the handle.

• Install the oil dipstick.

NOTE: The pump is pre-lubricated and sealed, requiring no additional lubrication for the life of the pump.

Add Engine Oil

IMPORTANT: Any attempt to crank or start the engine before it has been properly serviced with the recommended oil may result in an engine failure.

•Place pressure washer on a level surface.

•Refer to the engine owners manual to add recommended oil to engine.

NOTE: Check oil often during engine break–in. Refer to engine owner’s manual for recommendations.

Install Oil Dipstick on Pump	Add Gasoline
	WARNING! Never fill fuel tank indoors. Never
CAUTION! You MUST remove the pump’s shipping cap
and install the oil dipstick. Failure to do so will void the	fill fuel tank when engine is running or hot. Allow unit
	to cool for two minutes before refueling. Do Not
warranty and damage the pump.
	light a cigarette or smoke when filling the fuel tank.

To install the oil dipstick:

•	Make sure your unit is on a level surface.			WARNING! Do Not overfill the fuel tank.
				Always allow room for fuel expansion.
•	Remove and discard the shipping cap located on the
			•	Use regular UNLEADED gasoline with the pressure
	pump (Figure 3).
	Figure 3 — Install Oil Dipstick onto the Pump			washer engine. Do Not use premium gasoline. Do Not
				mix oil with gasoline.
	Remove shipping cap and	Shipping Cap	•	Clean area around fuel fill cap, remove cap.
	install oil dipstick here.		•	Slowly add "UNLEADED" regular gasoline to fuel tank.
				Use a funnel to prevent spillage. Slowly fill tank to about
				1.5" below the bottom of the filler neck (Figure 4).
				Figure 4 — Typical Fuel Expansion Space
				SpaceAir	Tank
				1.5”		Fuel
			•	Install fuel cap and wipe up any spilled gasoline.
	Pump Oil
	Dipstick
			6