Snapper 2700 PSI Pressure Washer
HOW TO USE YOUR PRESSURE WASHER
If you have any problems operating your pressure washer, please contact the local Snapper service center.
How to Start Your Engine
The best way to start your pressure washer for the first time is to follow these instructions
•Place the pressure washer in an area close enough to an outside water source that can flow at a rate of
2.8 gallons per minute or more.
•Make sure the unit is in a level position.
•Check that the high pressure hose is connected to the spray gun and to the pump. See “Preparing Pressure Washer for Use” on page 5.
•Connect the garden hose to the water inlet on the pressure washer pump and turn on the water.
CAUTION! Do Not run the pump without the water supply connected and turned on. You must follow this caution or the pump will be damaged.
•Squeeze the trigger on the spray gun to relieve the air pressure caused by turning ON the water. Water will discharge from the spray gun in a thin stream. Hold the trigger until a steady stream of water appears. This will make it easier to pull start the engine. Release the trigger.
•Apply the safety latch to the spray gun trigger (Figure 7).
Figure 7 — Spray Gun with Safety Latch Engaged
Safety Latch
• Move the fuel valve to the “On” position (Figure 8).
Figure 8 — Fuel Valve
•Move the throttle lever to the “Fast” position, shown on engine as a rabbit (Figure 9).
Figure 9 — Throttle Positions
•To start a cold engine, move the choke lever to the “Choke” position. To restart a warm engine, leave the choke lever in the “Run” position (Figure 10).
Figure 10 — Choke Positions
•Set the rocker switch to the “On” position (Figure 11).
Figure 11 — Stop Switch
•Grasp starter grip and pull slowly until you feel some resistance. Then pull cord out with rapid full arm stroke. Let rope return slowly. Do Not let rope “snap back” against starter.
8
