MAINTENANCE
CHANGING OIL IN GEAR REDUCTION (if equipped)
Change oil in gear reduction after every 100 hours of operation.
OIL FILLER PLUG
VENT HOLE
4 GEAR CASE COVER SCREWS
OIL LEVEL
PLUG
[1]To drain oil, loosen 4 gear case cover screws and drain oil into appropriate receptacle.
[2]After draining, torque 4 screws to 85
[3]To refill, pour SAE 30 oil into oil fill hole until it runs out level check hole.
[4]Replace both oil plugs.
Note: Oil filler plug has a vent hole and must be installed on top of gear case cover.
AIR CLEANER
All engines have an air cleaner cartridge. In addition, some engines have a
SCREWS
COVER
P/N 491435
CARTRIDGE
P/N 491588
OR 5043
BASE
REMOVING AND RE-INSTALLING AIR CLEANER
[1]Loosen screws and remove cover.
[2]Remove
[3]
[4]Replace cover and tighten screws.
CLEANING PRE-CLEANER AND CARTRIDGE
CAUTION: Do not use pressurized air or solvents to clean cartridge. Pressurized air can damage cartridge; solvents will dissolve cartridge.
Pre-cleaner
To clean
Cartridge
To clean cartridge, gently tap pleated paper side on a flat surface.
12