MAINTENANCE
ENGINE AND ENGINE PARTS
We recommend that you see an authorized Briggs & Stratton Service Dealer for all maintenance and service of the engine and engine parts. Use only genuine Briggs & Stratton parts.
WARNING | If you perform any maintenance on the engine, first disconnect the spark plug wire | ||
from the spark plug, and disconnect the battery at the negative terminal (electric | |||
| starter engines only) to prevent unintentional sparking. Unintentional sparking can | ||
| |||
| result in fire or electric shock. Unintentional | ||
| traumatic amputation or laceration. Use only correct tools. | ||
| • | Do not strike the flywheel with a hammer or hard object because the flywheel may | |
| |||
WARNING | |||
• | later shatter during operation. | ||
| Do not tamper with governor spring, links or other parts to increase engine speed. | ||
| |||
|
|
| |
|
|
| |
MUFFLER |
| COMBUSTION DEPOSITS |
WARNING | Replacement parts for the |
muffler must be the same and | |
| installed in the same position |
| |
| as the original parts, other- |
| wise fire can occur. |
If muffler is equipped with spark arrestor screen, re- move screen for inspection. Replace screen if damaged or
plugged.
SPARK PLUG
We recommend that after every
FUEL SYSTEM
WARNING | Replacement | parts for fuel |
system (cap, | hoses, tanks, | |
| filters, etc.) must be the same | |
| ||
| as original parts, otherwise | |
| fire can occur. |
|
|
|
|
Use only Briggs & Stratton Spark Tester (part number 19368) to check for spark.
AIR COOLING SYSTEM
Note: In some areas, local law requires using resistor spark plug to suppress ignition signals. If this en- gine was originally equipped with resistor spark plug, use same type for replacement.
.030” (0.76 mm) |
WIRE GAGE |
RESISTOR P/N 802592 |
STANDARD P/N 492167 |
We recommend cleaning the air cooling system every 100 hours.
CLEAN
OUT
DEBRIS
AND
CHAFF
CLEANING DEBRIS
CAUTION: Do not use water to clean engine parts. Water could contaminate fuel system. Use a brush or dry cloth.
WARNING
Engine parts should be kept clean to reduce the risk of overheating and ignition of accumulated debris.
Daily or before every use, clean accumulated debris from engine. Keep linkage, spring and controls clean. Keep area around and behind muffler free of any com- bustible debris.
CLEAN
Finger Guard
13
CLEAN |
Linkage, Springs, Controls |
CLEAN |
Muffler, Spark Arrester |