Briggs & Stratton HU80931 manual Adding OIL to the Engine, Adding Gasoline to the Fuel Tank, Cap

ASSEMBLY

ADDING OIL TO THE ENGINE

See Figure 4.

NOTE: This machine has been shipped with approximately 2 oz. of oil in the engine from testing. You must add oil to the engine before starting it the first time.

CAUTION:

Any attempt to start the engine without adding oil will result in engine failure.

Place pressure washer on a flat, level surface.

Unscrew the oil cap / dipstick by turning counter- clockwise.

Using 4-stroke engine oil (SAE 30), fill to the upper level of the oil filter neck (18 oz., 4-cycle engine oil provided).

Replace the oil cap / dipstick and securely tighten.

NOTE: This engine has a total oil capacity of 20 oz. (.6 liters).

ADDING GASOLINE TO THE FUEL TANK

See Figure 5.

WARNING:

Gasoline and its vapors are highly flammable and explosive. To prevent serious personal injury and property damage, handle gasoline with care. Keep away from ignition sources, handle outdoors only, do not smoke while adding fuel, and wipe up spills immediately.

When adding gas to the pressure washer, make sure the unit is sitting on a flat, level surface. If the engine is hot, let the

OIL CAP /

DIPSTICK

Fig. 4

FUNNEL

FUEL

pressure washer cool before adding gas. ALWAYS fill the fuel tank outdoors with the machine turned off.

NOTE: Use unleaded gas only. DO NOT mix oil with gas.

Before removing the fuel cap, clean the area around it. Remove the fuel cap.

Insert a clean funnel into the fuel tank then slowly pour gasoline into the tank. Fill tank to approximately 1-1/2 in. below the top of the tank neck (this allows for fuel expansion).

Replace fuel cap and tighten securely.

Clean up any spills before starting the engine.

CAP

Fig. 5

10