OPERATION
USING THE SPRAY WAND TRIGGER
See Figure 13.��
For greater control and safety, keep both hands on the spray wand at all times.
Pull back and hold the trigger to operate the pressure washer.
Release the trigger to stop the flow of water through the nozzle.
To engage the lock out:
Push up on the lock out until it clicks into the slot.
To disengage the lock out:
Push the lock out down and into its original position.
For the most effective cleaning, the spray nozzle should be between 8 in. and 24 in. from the surface to be cleaned. If the spray is too close it can damage the cleaning surface.
SLOT
LOCK OUT
Fig. 13
SELECTING THE RIGHT |
|
|
NOZZLE FOR THE JOB | NOZZLE |
|
See Figure 14 - 15. |
|
|
������Before starting any cleaning job, determine the best nozzle |
| |
for the job. Each of the three nozzles has a different spray |
| “CLICK” |
pattern. The nozzle patterns are: detergent (low pressure), |
| |
|
| |
25˚ (medium pressure), and 0˚ (high pressure). |
|
|
NOTE: For a gentle rinse, select the detergent nozzle. |
|
|
Scouring the surface requires a more direct spray of water. |
| |
Select the 0˚ nozzle for tough jobs. �Apply detergent using |
| |
| COLLAR | |
the detergent nozzle. |
| |
|
| |
�CAUTION: | SPRAY WAND |
|
NEVER change nozzles without locking the lock out on | EXTENSION | Fig. 14 |
| ||
|
| |
the spray wand. |
|
|
Using the
�Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
To connect a nozzle to the spray wand:
Push the nozzle into the
To disconnect a nozzle from the spray wand once the cleaning job is complete:
�Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure. | TRIGGER | |
Engage the lock out on the wand by pushing up on the | ||
| ||
lock out until it clicks into the slot. |
| |
Remove the nozzle by placing hand over nozzle then | Fig. 15 | |
pulling back the | ||
nozzle storage area on the top of the machine. |
|
14
