ASSEMBLY
WARNING:
If any parts are damaged or missing do not operate this tool until the parts are replaced. Failure to heed this warn- ing could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso- ries not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.
NOTE: Do not start the pressure washer until the engine has been filled with oil, all hoses are connected, and the water is turned on. Running this machine without oil will damage the engine; running this machine without water will damage the high pressure pump.
ATTACHING THE WHEEL ASSEMBLY
See Figure 2.
To attach the wheels to the pressure washer base:
Locate the axle, hitch pins, and wheels. Remove the hitch pin from the axle.
Slide the axle/washer through the hole in the center of the wheel.
Lift the machine and slide the combination into the wheel mounting hole in the machine base as shown.
Push the hitch pin into the hole on the end of the axle to secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until the center of the pin rests on top of the axle.
Repeat with the second wheel.
INSTALLING THE TELESCOPING HANDLE
See Figure 3.
To install the telescoping handle:
Align the arrows on the
Push and hold the button on the handle as you slide the handle into the holes in the frame.
Lock the handle in place by aligning the slot in the handle lock cap with the pin on the housing bar. Next, push the handle lock cap down while turning the cap clockwise.
NOTE: Before use, pull the handle up until the lock button snaps through the locking slot to secure the handle in place.
WASHER | HITCH |
AXLE | PIN |
|
Fig. 2
HANDLE
LOCK CAP
PUSH TO
INSERT
Fig. 3
9
