3M 40800 INSTALLATION continued, 7.19Completion of Taping Heads, Outboard Tape Roll Holder

7-INSTALLATION (continued)

7.19Completion of Taping Heads

See Manual 2 for Complete Instructions:

Important – Do not cut against the apply roller - roller damage could occur.

7.20 Outboard Tape Roll Holder

If you intend to use the outboard tape roll holder, proceed as follows:

1 - Remove the lower taping head from the machine. 2 - Remove the tape drum bracket assembly, stud

spacer, and fasteners from the lower taping head. 3 - Install alternative wrap roller and bracket on the

head in place of tape bracket. Replace lower head into machine.

4 - Install and secure tape drum bracket assembly on the entry end of the lower frame (as shown in Figure 7-22).

7.21 Preliminary Electric Inspection

Before connecting the machine to the mains please carry out the following operations:

7.21.1Make sure that the socket is provided with an earth protection circuit and that both the mains voltage and the frequency match the specifications on the name plate.

7.21.2Check that the connection of the machine to the mains meets the safety regulations in your country.

7.21.3The machine is fitted with a main switch. The user will be responsible for testing the short-circuit current in its facility and should check that the short-circuit amperage setting of the machine is compatible with all the components of the mains system.

Figure 7-22

7.22 Machine Connection to the Mains

-Push the LATCHING EMERGENCY STOP BUTTON.

-The main switch is normally turned OFF.

Connect the power cord supplied with the machine to a wall socket using a plug which complies with the safety regulations of your country.

7.23 Inspection of Phases

(For Three-Main Phases Only)

N/A for this machine.

700r-NA 31 2011 July