3M 40800 operating instructions Set Up And Adjustments

11 - SET UP AND ADJUSTMENTS

11.1 Box Width Adjustment

Boxes are automatically centered by the Side Guides (Figure 11-1).The Side Guides are triggered by the Centering Guide Switch which is located on the machine bed. Side Guides air pressure adjustments can be made using the Centering Guide Air Pressure Regulator (See Figure 9-8).

11.2 Box Height Adjustment

Box Height is automatically determined when the Upper Drive Assembly Actuator Switch is engaged which is located on the front of the Upper Drive Assembly (See Figure 11-2). .The Upper Drive air pressure adjustments can be made using the Centering Guide Air Pressure Regulator

(See Figure 9-8).

11.3Adjustment of Top Flap Compression Rollers

(Not Applicable to this Machine)

11.4Changing the Tape Leg Length

Taping heads are preset to apply 70mm [2.75 inches] long tape legs. To change tape leg length to 50mm [2.0 inches], refer to Instructions below and also to Manual 2, "Removing Taping Heads Procedure - Changing the Tape Leg Length".

With upper drive assembly in raised position:

1.Remove tape from upper taping head.

2.Pivot up the clamp that secures the upper taping head.

3.Hold upper taping head applying and buffing arms from under upper assembly, slide head forward and down to remove. See Figure 11-3.

4.Lift the lower taping head, shown in Figure 11-4, straight up to remove it from the case sealer bed.

5.Refer to Manual 2, "Adjustments – Changing Tape Leg Length," for taping head Setup.

6.Replace taping heads reverse of disassembly. Turn on air supply and electric power, unlatch upper drive assembly and allow it to return to its rest position.

	Upper Drive
Figure 11-2
	Actuator Switch

Figure 11-3 – Remove Upper Taping Head

Figure 11-1

700r-NA

Figure 11-4 – Remove Lower Taping Head

37 2011 July