3M 40800 INSTALLATION continued, Removal of Plastic Ties, Figure Figure, in position Figure

7-INSTALLATION (continued)

7.5 Removal of Plastic Ties

Cut the plastic which attaches the top head to the frame and remove the polystyrene blocks (Figure 7-4).

Cut the plastic strap which attaches the strip and the

EMERGENCY STOP cable to the frame (Figure 7-5).

Figure 7-4

Figure 7-6

		7.6 Assembly Completion / Machine Setup
		1. Install the upper tape drum bracket on the top
		crossbar as shown in Figure 7-7A.
	Figure 7-5	2. The column guards, shown in Figure 7-7have
		been installed upside down for shipping. Remove
		and retain the screws and washers holding the
Cut the plastic ties holding the lower taping head		guards on the columns for re-installation after
		the Bumper Supports have been mounted (see
in position (Figure 7-6).
		Column Bumper Installation in the Installation
		and Setup Section and Special Setup Procedures
		Section / Figure 7-7). After the Bumpers have
		been installed, the Column Guards must be
		repositioned (rotated 180° and re-installed -
		Figure 7-7) for safe operation of the machine.
		Replace existing screws and washers to secure
		the guards in place.
		3. Cut cable ties securing upper assembly to
		machine bed on each side.

700r-NA 20 2011 July