3M 40800 operating instructions Operators Qualifications, Number of Operators, Residual Hazards

3-SAFETY(continued)

3.4 Operator's Qualifications

-Machine Operator

-Mechanical Maintenance Technician

-Electrical Maintenance Technician

-Manufacturer’s Technician/Specialist

3.5 Number of Operators

The operations described below have been analyzed by the manufacturer; the recommended number of operators for each operation provides the best and safest work performance.

Note: A smaller or greater number of operators could be unsafe.

3.6Instructions for a Safe Use of the Machine / Definition of Operator's Qualif cations

Only persons who have the skills described in the skill levels section should be allowed to work on the machine. It is the responsibility of the user to appoint the operators having the appropriate skill level and the appropriate training for each category of job.

3.7 Residual Hazards

The case sealer 700r incorporates various safety protections which should never be removed or disabled. It is essential that the operator and service personnel be warned that hazards exist which cannot be eliminated.

WARNING

•To reduce the risk associated with mechanical and electrical hazards:

−Read, understand, and follow all safety and operating instructions before operating or servicing the case sealer.

−Allow only properly trained and

qualified personnel to operate and service this equipment.

3.9Personal Safety Measures

Safety glasses, safety gloves, safety helmet, safety shoes, air filters, ear muffs - None is required except when recommended by the user.

3.10Predictable Actions which are Incorrect and Not Allowed

-Never try to stop/hold the box while being driven by the belts.

-Never remove or disable the safety devices.

-Only authorized personnel should be allowed to carry out the adjustments, repairs or main- tenance which require operation with reduced safety protections. During such operations, access to the machine must be restricted. When the work is finished, the safety protections must immediately be reactivated.

-The cleaning and maintenance operations must be performed after disconnecting the electric power.

-Do not modify the machine or any part of it.

3.8Recommendations and Measures to Prevent Other Hazards which Cannot be Eliminated

-The operator must stay on the working position shown in the Operation Section. He must never touch the running driving belts or put his hands inside any cavity.

-The operator must pay attention to the blades during the tape replacement.

-Clean the machine using only dry cloths or

light detergents. Do not use solvents, petrols, etc.

-Install the machine following the suggested layouts and drawings.

700r-NA 8 2011 July