3M 40800 operating instructions INSTALLATIONAND SETUP continued

7-INSTALLATION AND SETUP (continued)

7.7 Infeed Conveyor Assembly

1.Remove the conveyor and the package of parts from the carton.

2.Verify that the package contains two right angled cover plates, twelve (12) M8 x 15 hex head screws, and eight (8) M8 flat washers.

3.To assemble the infeed conveyor, refer to Figure 7-9and locate four bolt holes on the infeed end of the case sealer frame.

4.Insert a M8 x 15 screw in each hole so that only a few threads take hold.

Do not use washers with these screws.

5.Attach the infeed conveyor over the screws using the inverted keyholes in the end of the conveyor. Tighten all four (4) screws with a 13mm wrench.

6.Refer to Figure 7-10. Set the cover plates over

the joint between the conveyor and the frame on
	Figure 7-9 – Infeed Conveyor
each side and secure them with four (4)
M8 x 15 screws and M8 washers.

7.8 Centering Guides

1.Remove the two centering guides and four (4) M6 x 20 socket head screws from the package.

2.Using a 5mm hex key wrench, attach the centering guides to the rails with four (4) M6 x 20 screws (two [2] in each guide as shown in Figure 7-11).

7.9Outboard Tape Roll Mounting

(Lower Taping Head)

Remove the tape drum bracket assembly, spacer and fasteners from the lower taping head. Install and secure on the infeed end of the lower frame, as shown in Figure 7-8.

7.10 Tape Leg Length
	Figure 7-10 – Cover Plates

Taping heads are pre-set to apply 70mm [2.75 inch] long tape legs. To change tape leg length to 50mm [2.0 inch], see "Special Setup Procedure – Changing the Tape Leg Length."

Figure 7-8

A
Lower
Taping
Head
Mounting B		Figure 7-11 – Centering Guides
700r-NA	23	2011 July