OPERATION

APPLICATIONS

You may use this tool for the purposes listed below:

Removing dirt and mold from decks, cement patios, and house siding

Cleaning cars, boats, motorcycles, outdoor furniture, and grills

STARTING AND STOPPING THE PRESSURE WASHER

See Figures 11 - 12.

CAUTION:

Do not run the pump without the water supply connected and turned on.

Before starting the engine:

Connect all hoses.

Check all fluids (oil and gas).

Turn the garden hose on then squeeze the trigger to relieve air pressure; hold the trigger until a steady stream of water appears.

To start the engine:

Push primer bulb 3 times.

NOTE: If starting the engine for the first time, push the primer bulb 5 times.

Grasp the recoil starter and pull slowly until resistance is felt. Give the recoil starter a short, brisk pull to start the engine.

To stop the engine:

On the top of the engine is an OFF ( O ) switch. Press and hold the switch in the OFF position for three (3) seconds or until the engine stops.

PRIMER BULB 3X

RECOIL

STARTER

Fig. 11

OFF SWITCH

Fig. 12

13

Page 13
Image 13
Briggs & Stratton HU80530, HU80931 manual Applications, Starting and Stopping the Pressure Washer, Recoil Starter OFF Switch