INSTR-800-2200-0_Dual Xenon.qxd 6/24/03 3:23 PM Page 4
IMPORTANT: The EPA
Certified RBRC® Battery
Recycling Seal on the lead
acid (Pb) battery
contained in our product
indicates The Brinkmann Corporation is voluntarily
participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC® program provides a convenient alternative to placing used Pb batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call
To Replace Bulb
Glass &
Reflector
Rear
Housing
GlassRubber
Retainer Cap
Step 4: Allow the spotlight to charge for at least 8 hours. Do not allow to charge more than 12 hours.
Note: LED indicator on base of handle turns off automatically when battery is fully charged.
Step 5: Remove spotlight from the charger before operating.
See chart for recommended charge times.
Charge Times
Charge time is dependent on usage of the
product. See chart below for recommended charge time.
85
(Minutes) | 40 |
|
| Battery Charge |
|
| |||
|
|
| ||
USAGE |
|
|
| |
|
|
|
| |
|
|
|
|
4 | 8 | 12 |
CHARGE TIME (Hours)
Only use Brinkmann xenon bulb that is designed for the Dual Xenon spotlight as a replacement. Use of any other bulb may result in poor performance and may damage your spotlight.
NOTE: Handling the bulb can leave oil from your fingers on the bulb. To extend the life of the new bulb and maximize brightness, gently clean off bulb with soft cloth or tissue. Make sure the reflector does not touch or bend the bulb while replacing spotlight head.
Step 1: Disconnect spotlight from charger.
Step 2: Remove front rubber cap from barrel of spotlight.
Step 3: Pinch the wings of the glass retainer together and lift as illustrated.
Step 4: Pull glass and reflector away from rear housing.
Step 5: Pull old bulb straight out of bulb holder.
Step 6: Make certain that "legs" on new bulb are straight. Insert "legs" into the two holes in the bulb holder.
Step 7: Gently push bulb straight in until fully seated and centered.
Step 8: To reassemble, place the glass and reflector on the rear housing. Insert the glass retainer into the rear housing.
Step 9: Replace rubber cap.
WARNING: Do not touch the lamps when light is on or if it was recently on. The lamps will be hot and could cause serious burns.
3
