5
Step 5
With the help of a friend, set the unit
upright. Try to minimize stress on the legs
of the grill.
Step 6Insert wire wood rack (curved ends
pointed down) into holes on bracket near
bottom of legs then tighten all bolts until
secure.
Step 7
Attach hood stops to the outside back of
the body using M6 x 12 bolts. Thread
bolts into welded nuts and tighten until
secure.
Step 8
Attach the hinges (with the spine side out)
to the outside back of the body using
M6 x 12 bolts. Thread bolts into welded
nuts but do not tighten at this point. Place
lid over the body and attach hinges to the
outside back of the lid using M6 x 12
bolts. Thread bolts into welded nuts.
Tighten all hinge bolts on lid and body
until secure.
Step 9Attach handle to the lid using two M5 x 75
bolts, flat washers, spacers, spring
washers and M5 x 4 hex nuts. The heads
of the bolts should be slightly recessed
into the wooden handle when fully
tightened. Hood
Stop
Hood
Hinge
M5 x 75
bolts
curved end
pointed down
M6 X 12
bolts
Flat
washer Spacer Spring
washer M5 X 4
hex nut