Installing the Child Seat: Harness Mode
1 Rotate the recline block to the front and place the child seat on the vehicle seat.
* Ensure harness height is adjusted to fit your child.
2Pull the vehicle belt out and
route the belt through the first belt slot, under the cover and through the second belt slot.
3 Verify that the belt is not twisted, then buckle.
4 Push the child seat firmly |
|
|
into the vehicle seat while |
|
|
removing all slack from the | 2 |
|
vehicle belt. | 3 |
*Ensure that the vehicle belt is locked as directed by your
vehicle owner’s manual.
* The child seat is secure when it cannot be moved
(2.5 cm) at the belt path. If the child seat is not secure, repeat the installation procedure or use a different seating location.
5 Firmly press the | OR |
hook to the vehicle tether |
|
anchor to attach. Remove all |
|
slack from the tether webbing. | OR |
6 Use the elastic strap to contain extra webbing.
Checklist
99Check that positioning block is rotated to the front.
99Check all connections and verify that child seat is secure.
*The child seat is secure when it cannot be moved
99Ensure any excess
Switching Between Modes
This seat may only be used in booster mode with children who stand 42 – 65 in. (106.7 – 165.1 cm) in height and weigh more than 40 lbs (18.1 kg). Britax recommends booster mode only after the child outgrows harness mode.
Harness to Booster Mode
To remove the harness and buckle:
1Loosen the harness.
a Press release lever
b Pull both harness straps forward
2 Remove the belt shield and unhook the harness straps from the yoke.
3 Replace the belt shield (a) then store the yoke in the slot (b).
4Pull the harness straps out of the slots.
* DO NOT remove the HUGS™ chest pads or chest clip.
5On the bottom of the seat,
slide the retainer of one harness strap up and pull it away from the child seat shell.
30 | 31 |
