Child Seat Functions
Child Seat Functions
Storing the LATCH Connectors
When the LATCH connector is not in use, lift the cover to access the LATCH storage slots (Fig. A). Fold the LATCH adjuster and the connector, then slide each set into the adjacent slot.
NOTE: Child seats are shipped from Britax with the |
| ||
LATCH connectors in the storage slots. | a | ||
Recline Adjustment |
| ||
| |||
| |||
Pull the recline handle (Fig. B) then slide the child seat shell into the desired position. Release the recline handle, then verify the child seat has locked into position.
| WARNING! |
|
|
| |
• This child seat must be in the reclined | b | |
| position when used | |
• This child seat must be in full upright position |
| |
| ||
| ||
| when installed |
|
Chest Clip
Fastening the Chest Clip
Fasten the chest clip by pushing the two halves together until a positive click is heard (Fig. D).
Releasing the Chest Clip
1Squeeze the middle tabs together (Fig. E).
2Pull the two pieces apart.
Adjusting the Chest Clip
1Slide the chest clip up or down (Fig. F) on the harness so it is positioned at the middle of the child’s chest, level with the child’s armpits.
2Slide the HUGS™ chest pads and comfort pads to a comfortable location for the child.
HUGS™ Chest Pads
d |
e |
weigh more than 33 lbs (15.1 kg). |
|
NOTE: It will be necessary to loosen the tether, |
|
vehicle seat belt, and/or LATCH strap before |
|
adjusting the recline position. The tether, vehicle |
|
seat belt, and/or LATCH strap must be properly re- | c |
tightened after adjusting the recline position. |
Infant Body Pillow
The Infant Body Pillow is designed to provide better fit and comfort for infants using this child seat. For additional side support, fold the side flaps inward (Fig. C).
NOTE: Remove the Infant Body Pillow after child can sit comfortably in the child seat without additional support.
WARNING! HUGS™ chest pads must be installed for
f
30 | 31 |
