Care and Maintenance
Cover Removal
WARNING! Do not take apart the harness. Never remove the buckle tongues from the harness. They cannot be reattached after removal. If reassembled incorrectly,
the child seat may not perform as intended.
1 Loosen the harness by lifting the harness adjuster lever while pulling the shoulder straps forward as far as possible.
2 Unhook the shoulder straps from the harness yoke on the rear of the child seat (Fig. A).
3 Pull the upper harness straps through the shell A and cover to the front of the child seat.
4Remove the buckle and belly pad (page 36).
5Gently remove the upper portion of the cover. Be careful not to damage the
6Pull the lower harness straps, buckle tongues, HUGS™ chest pads, and chest clip through the lower slots in cover.
7Remove the entire cover from the child seat.
For additional demonstration please visit www.BritaxUSA.com.
Refitting the Cover
To refit the cover, reverse the above directions. Make sure that the shoulder straps are not twisted, and are threaded properly through the chest clips, cover, foam and shell.
Care and Maintenance
Cleaning the Cover
•HAND WASH using cold water and mild soap.
•LINE or
•DO NOT bleach, machine wash, machine dry or iron.
Cleaning the Shell
•SPONGE CLEAN using warm water and mild soap.
•TOWEL DRY
•DO NOT use solvents or abrasive cleaners.
Cleaning the Harness
•SPONGE CLEAN using warm water and mild soap.
•TOWEL DRY
•DO NOT bleach, machine wash, machine dry or disassemble the harness.
Cleaning the Harness Adjuster
Periodically check the adjuster area to be sure it is clean and free of food, drink or other debris. If debris is present, it must be removed to prevent interference with the adjuster mechanism.
•BRUSH AWAY LOOSE DEBRIS using a
•SPONGE CLEAN using warm water and a mild soap.
•TOWEL DRY
•DO NOT use solvents, abrasive cleaners or disassemble the harness.
34 | 35 |
