Restraint Functions
Switching the LATCH Harness
The LATCH harness must be switched for proper alignment in rear facing (Fig.
D)or forward facing (Fig. E) installations. Complete the following procedure to switch the connectors.
NOTE: LATCH connectors must be in an upright position (as shown in figure G) and strap should be tight and not twisted to ensure proper installation.
1 Pull the LATCH harness and connectors out of the current belt path OR from the storage slots (Fig. F).
2 Align the LATCH harness in the appropriate belt path.
•Refer to figure D for
• Verify that the harness is not twisted.
3Follow instructions for restraint installation with LATCH.
D
E
Release
Button Top
F
G
27
