Installation: Forward Facing

 

 

 

LATCH Installation

 

 

 

• Figure A illustrates a typical forward-facing LATCH installation.

 

 

• Verify that your vehicle is equipped with LATCH anchors. If

 

 

LATCH anchors are not available, you must use vehicle belt

 

 

installation methods.

 

 

 

NOTE: LATCH connectors must be in an upright position (as

 

 

shown in figure B) and strap should be tight and not twisted

 

 

to ensure proper installation.

 

A

 

1� If stored, remove LATCH connectors from storage slots

 

under cover (see page 28).

 

 

 

2� Press and hold first LATCH adjuster button, then pull

 

 

LATCH strap to full length. Repeat for remaining LATCH

Release

 

connector.

 

Button

Top

3� Place restraint sideways on vehicle seat, with back

of

restraint facing toward you.

 

 

 

• Restraint can be used in recline position when installed in

 

 

forward-facing mode with children up to 40 pounds (18 kg.).

 

 

• Britax recommends use of Versa-Tether®to improve

B

 

installation. If using Versa-Tether®(see pages 23-26), locate

 

tether on rear of restraint and place up and over seat back

 

 

while securing restraint.

 

 

 

4� Verify LATCH strap is not twisted, then attach closest LATCH connector to vehicle seat back to farthest LATCH anchor from you (fig. C).

NOTE: It may be necessary to switch LATCH harness as shown on page 27 if ANY of the following conditions exist:

LATCH connector is not in an upright position as

 

 

shown in figure B.

C

• LATCH strap is twisted.

A positive click is NOT heard when LATCH connector

 

and LATCH anchor are connected.

NOTE: If a positive click is not heard, but LATCH connector is in an upright position, you should not switch LATCH harness. The strap may be too tight or twisted, or

there may be debris in LATCH connector. If a positive connection cannot be made, do not use LATCH installation; install using vehicle belt method.

18

Page 20
Image 20
Britax Diplomat manual Installation Forward Facing