Installation Instructions
INSTALLING THE PEDESTAL (if desired) (cont.)
4 LEVEL THE WASHER OR DRYER
AStand the washer or dryer upright. Move it close to its final location.
BMake sure that the washer or dryer is level by placing a level on top. Check side to side and front to back.
CUse an open
ended wrench
to adjust the legs in and out. Tighten the lock nut against the bottom of
the pedestal.
NOTE: To minimize vibration, the locking nuts must be tight.
6 REMOVE SHIPPING SCREWS
Remove the 4 shipping screws on the back side of the washer.
7 FINALIZE THE INSTALLATION
Refer to the washer or dryer Installation Instructions to complete the installation.
5 REINSTALL THE DRAWER
A
B
C
D
Check to be sure the slides are closed.
Slide the drawer | Drawer |
into the | Divider |
| |
opening. Align |
|
the drawer |
|
supports to the |
|
slides on each |
|
side. |
|
Reinstall the original screws into each drawer slide. Tighten both
screws.
Open the drawer fully. Slide drawer divider into slots in the center of the drawer. The drawer should slide smoothly when you push it closed.
45
