6.Line the mounting bracket up over the plastic screw anchors.
7.Screw the mounting bracket
to the ceiling or wall through the mounting slots using the two screws provided.
8. Before attaching the alarm to the
bracket, insert the 9V battery (included) into
the battery compartment.
Match the terminals on the
end of the battery with the terminals on the
unit. Match “+”
to “+” and
NOTE:
The unit may beep briefly when you install the battery. This is normal.
WARNING!
The battery door will not close unless a battery is installed. This warns you the unit will not operate without a battery.
9.Align the tabs on the base with the tabs on the mounting bracket. Turn the base until it snaps into place.
10.If the cover does not line up the way you wanted, adjust it by slowly rotating it in either direction.
11.Test the smoke/CO alarm. See “Weekly Testing” (page 14) for details.
9