Broan E55000 Install Flue Mounting Bracket, Prepare The Hood, Ducted And Non-Ducted Hoods, 270 mm

INSTALL FLUE MOUNTING BRACKET

DUCTED AND NON-DUCTED HOODS

1.Assemble the flue mounting bracket, adjusting outside width as shown. Fig.8

2.Carefully center the mounting bracket directly over the range hood location.

3.Secure the bracket assembly to the ceiling using (2) 4.8x38mm mounting screws and drywall anchors (Fig. 9). Make sure the bracket is pushed into the corner, tight against the wall and centered over the hood.

FLUE MOUNTING BRACKET

3.9x 6 mm FLAT HEAD BRACKET SCREWS

10-5/8”

(270 mm)

FIG. 8

DRYWALL ANCHORS
4.8x38mm
MOUNTING SCREWS	FIG. 9

PREPARE THE HOOD

Note: On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the hood and decorative flues, prior to final installation.

DUCTED CONFIGURATION

1.Remove the tape on the electrical system plate; place the electrical system plate on the hood (use a protection). Fig. 10

2.Install the discharge collar into the duct connector of the range hood. Fig. 11

ELECTRICAL SYSTEM

PLATE

DISCHARGE COLLAR

DUCT

CONNECTOR

PROTECTION

FIG.10

FIG.11

- 10 -