Non-ductedrecirculationConfiguration

1.Adjust the width of the flue mounting bracket to equal the inside width of decorative flue. Insert and tighten mounting screws to hold bracket width.

2.Use mounting screws and drywall anchors to secure flue mounting bracket to the ceiling as shown.

3.Turn upper flue section upside down so air vents are at the top. Slide upper flue section into lower flue section.

4.Connect the non-ducted recirculation plenum to the upper flue section with (4) flat-head screws (supplied).

5.Install the reduction on the discharge collar.

6.Measure the distance from the top of the reduction to the ceiling. Cut a length of 5" round metal duct 5" shorter than this dimension.

7.Fit duct section over the non-ducted recirculation plenum. For best fit, make sure duct seam is toward the front.

8.Set duct/flue assembly on hood with top tilted away from wall. Reach around flue to engage bottom of duct with discharge collar on hood.Tilt flue up against wall. Duct seam can be cut to length if necessary.

9.Extend the upper flue to the ceiling and secure with the mounting screws.

UPPER

AIR

UPPER

FLUE SECTION

VENTS

BRACKET

 

 

(in upper flue section)

 

 

NON-DUCTED

 

 

 

 

RECIRCULATION

 

 

 

 

 

 

 

 

 

 

PLENUM

 

 

 

 

 

 

 

MEASURE

 

 

 

 

 

LOWER

 

 

 

 

FLUE SECTION

DUCT

 

 

5" ROUND

 

 

SEAM

 

 

METAL DUCT

 

 

 

 

REDUCTION

 

 

 

 

DISCHARGE

 

 

 

 

COLLAR

 

 

 

 

MOUNTING SCREWS

MOUNTING SCREWS

=

=

FASTEN FLUE TO UPPER BRACKET

WITH MOUNTING SCREWS

- 8 -