PREPARE THE HOOD
NON - DUCTED CONFIGURATION, cont’d.
8.Carefully place the lower decorative flue into the recessed area of the range hood top. Fig. 7
9.Carefully slide the upper decorative flue down inside the lower flue.
Note: air vents must be up. Fig. 7
10.Secure the recirculation plenum to the upper flue with (4) flat head screws. Fig. 9
| PLENUM |
| 4 FLAT |
| HEAD |
UPPER | SCREWS |
| |
FLUE | FIG. 9 |
|
INSTALL THE HOOD
Note: at least two people will be required to mount the hood.
1.Raise the hood into its mounting position.
2.Plug the power cord into the electric wall receptacle. Tuck excess cord behind the flue.
| MOUNTING | WALL FRAMING |
| SCREWS | |
SCREWS |
| |
(4.8x38mm) |
| |
(3.9x9.5mm) |
| |
|
| |
MOUNTING |
|
|
SCREWS |
|
|
(4.8x38mm) |
|
|
|
| MOUNTING |
|
| BRACKET |
|
| RECTANGULAR |
|
| CUTOUT |
|
| FIG.10 |
3.Align the rectangular opening on the back of the hood with the
4.Level the hood with 2 screws (3.9x9.5mm) and secure with (4) mounting screws. Use drywall anchors provided if wall studs or framing are not available. Fig. 10
5.Raise the upper flue until its holes align with holes in the flue mounting bracket (located on ceiling). Fig. 11
6.Secure the flue with (2) mounting screws. Fig. 11
3.9x9.5mm
MOUNTING SCREWS
- 10 -
FIG.11
