42 EZSwitchSetup Administrator’s Guide
53-1002157-01
Zoning management
3
Viewing the zone access map
Click View under Zoning in the task panel to view the Zone Access Map for Devices (Figure 40). If
you have no devices or if you have only one device, the zoning map does not display.
The HBA and storage device names displayed in the matrix are the alias names of the devices (see
“Assigning and renaming device aliases” on page38 for additional information). If no aliases are
assigned, devices are identified by WWN. When aliases are assigned, you can see the WWN in a
tool tip by hovering the mouse cursor over the alias.
FIGURE 40 Zone Access Map
Some HBAs and storage devices can be configured with dual initiator and target capability. Such
devices are displayed as storage devices in the matrix. If all of the attached devices are
dual-capable, the Switch Manager thinks there are no hosts and does not display the matrix or
allow zone configuration. In this case, you must either reconfigure some of the devices to be
host-only to continue using the EZSwitchSetup Switch Manager or use Web Tools as your switch
management tool.
Editing the zoning configuration
You can customize which HBAs can access which storage devices by clicking Edit in the Zoning task
panel. This starts a wizard that creates a new Custom Zoning scheme based on your device
accessibility choices.
If you make any zoning changes to the default Typical Zoning configuration, you will be creating a
Custom Zoning configuration to replace it. You can later restore the Typical Zoning configuration by
clicking Restore Default Typical Zoning in the task panel.
NOTE
If all devices are dual-configured, you cannot proceed. Ensure that at least one initiator device is not
dual-configured to proceed with this Zoning wizard.
1. Click Edit under Zoning in the task panel.
A wizard launches, briefly displaying the Zone Access Map for Devices.