Broilmaster C3-1 owner manual Rear Support Bracket, Load Door, Adjusting Door Latches

GRILL ASSEMBLY

Rear Support Bracket

1.Align the four holes and attach the rear support bracket to the back inside of the lower grill body with four #10-24 x 3/8” screws and four #10-24 keps nuts. See Figure 3.

Figure 3

Load Door

1.Attach one door pivot using one #10-24 x 1/2” carriage bolt and one #10-24 keps nut on the front of grill body bottom.

2.Insert the load door swing pin into the already attached door pivot. While holding the door in place slide the second door pivot on the opposite side door swing pin. Attach the second door pivot to the front of the grill body bottom using one #10-

24 x 1/2” carriage bolt and one #10-24 keps nut. See Figure

4.

SWING PIN

DOOR PIVOT

Figure 4

Adjusting Door Latches

1.The doors should be checked for a tight fit when doors are latched.

2.If the door latches need to be adjusted loosen the set screw on the latch pawl with a 1/8” Allen wrench.

3.Slide the pawl in or out on the shaft to adjust for the proper tension when the door is closed. Retighten set screw. See

Figure 5.

Figure 5

Attach Top Smoke Vent Assembly

1.Attach the vent base and vent top with one 1/4-20 x 3/4 truss head screw and two 1/4-20 hex nuts. Hand tighten first nut against vent base. Tighten second nut against the first (as a jamb nut) using a 7/16 wrench. See Figure 6.

Figure 6

Page 10 B102097-0-0113