GRILL ASSEMBLY
Radiation/Wind Shield | Burner Assembly | |
Place the radiation/wind shield in the grill bottom. | 1. | Place the Burner Body, with the ports facing up, on a flat surface. |
See Figure 10. | 2. | Place the Gasket on the Burner Body, aligning the holes. |
| 3. | Set the Venturi Assembly on the Gasket again aligning the |
|
| holes. See Figure 11. |
| 4. | Align hole on burner bracket with the left front hole on Venturi |
|
| Assembly as shown in Figure 11. |
| 5. | With all holes properly aligned, using four #10 x 1/2 Phillips |
|
| Truss Head Screws, attach the Venturi Assembly to the Burner |
|
| Body. See Figure 11. Do not tighten the screw securing the |
|
| burner bracket to the venturi assembly. |
Figure 10
“P” series
“H” series
Figure 11
Page 26 |