This calibration process uses the special black and white calibration sheet (see picture on page iv) that was included with your scanner. When calibrating, make sure the side with the black bar is facing down and note the direction of the arrows for proper insertion.

When the calibration process has been completed successfully, you will see the message above; otherwise you will need to re-calibrate again.

If you switch scanners or your image quality has become unsatisfactory, you can

re-calibrate your scanner by choosing the CUSTOM button in the DSmobileSCAN

II window and select the Calibrate button.

If you lose or forget the black and white calibration paper that was included with your scanner, you can use any plain “White” (the brighte r the “White” the better) piece of letter size (or A4) printer paper to perform the calibration. Simply fold the paper in half and insert the end opposite the fold into the scanner first when calibrating. The following message will be displayed (see below).

12

Page 29
Image 29
Brother 600 manual