Brother 885-V35/V37 Reattach the bobbin cover, When pulling up the bobbin thread may be necessary

————————————————————————————————————————————————————

Note

zIf the thread is not correctly inserted through the tension-adjusting spring of the bobbin case, it may cause incorrect thread tension (page 62).

a

a Tension-adjusting spring

iReattach the bobbin cover.

Insert the tab in the lower-left corner of the bobbin cover, and then lightly press down on the right side.

a	b
		2

1

aTab

bLower-left corner

XThe bobbin threading is finished. You can begin sewing without pulling up the bobbin thread.

Next, thread the upper thread. Continue with the procedure in "Upper Threading" (page 31).

Memo

zWhen making gathers or before free-motion quilting, pull up the bobbin thread by following the procedure in "When pulling up the bobbin thread may be necessary".

■When pulling up the bobbin thread may be necessary

When making gathers or before free-motion quilting, first pull up the bobbin thread as described below.

a Thread the upper thread. 1

• Refer to "Upper Threading" (page 31).

bInsert the bobbin into the bobbin case.

•Refer to steps c through f of "Installing the bobbin" (page 28).

cPass the bobbin thread through the slot.

Note

zDo not cut the thread with the cutter.

zRemove the bobbin cover.

dWhile lightly holding the upper thread with

your left hand, press (Needle position button) once or twice to raise the needle.

a

aNeedle position button

XThe bobbin thread is looped around the upper thread and can be pulled up.

Winding/Installing the Bobbin 29