Brother 885-V35/V37 Error messages, Was pushed at a LCD screen other than the sewing LCD screen

————————————————————————————————————————————————————

Error messages

When erroneous operations are performed messages and advice on operation will be displayed on the

LCD. Follow what is displayed. If you press or do the operation correctly while the error message is displayed, the message disappears.

No	Error Message	Probable Cause
1		There is a possibility that the data for the selected pattern is corrupted.

2	Either the start/stop button or the reverse/reinforcement stitch button
	was pushed at a LCD screen other than the sewing LCD screen.
	The start/stop button was pressed without connecting the foot controller
3	when the setting for adjusting the stitch width using the sewing speed
	controller is set to "ON" .
	You have selected a pattern for which the stitch width control cannot
	be used. (page 107)
4	The twin needle setting is selected while a pattern that cannot be sewn
	with the twin needle is selected.
	Upper thread broken.
	Upper thread not set up correctly.
	Upper thread has run out.
5	CAUTION
	Be sure to rethread the machine. If you press	(Start/stop button)
	without rethreading the machine, the thread tension may be wrong or
	the needle may break and cause injury.
6	You tried to create a design with too many points with the My Custom
	Stitch function.
7	The machine is deleting a previously saved pattern while in embroidery
	edit mode.
8	The start/stop button was pressed while the foot controller was
	connected.
	You tried to use the foot controller for embroidery.

5

Troubleshooting 181