Brother NC-9100H How to Select the Print Server (AppleTalk/EtherTalk)

7 - 3 PRINTING FROM A MACINTOSH®
NC9100h_FM6.0
Before you try to use the Brother print server, you must first enable
the EtherTalk protocol from the Network Control Panel on the
Macintosh®. If the EtherTalk protocol is not selected, or the Network
Control Panel does not exist, you must use Apple's Network
Installer software to add these capabilities.
The appropriate PPD file supplied with your machine must first be
installed. Insert the CD-ROM into the CD-ROM drive of your
computer. Select the Start Here icon, select your language and
follow the on-screen instructions for Install Software.
Figure 1 Typical Macintosh Installer
The above screenshot is from a Brother HL-7050 series printer
driver. However, you will see a similar screen for all Brother printers
that include a Macintosh printer driver.
How to Select the Print Server
(AppleTalk/EtherTalk)
Once the Print/Fax server is connected on your network and the
machine is powered on, the Brother print server’s AppleTalk service
name (default is BRN_xxxxxx_P1_AT, where xxxxxx is the last six
digits of the Ethernet address (MAC address) should appear in the
Chooser.
You can find the service name and MAC address by printing
out the configuration page. For information on how to print
the configuration page on your print server, see Resetting the
Print/Fax Sever back to factory settings (Test Switch) on
page 13-4.