Brother NV6000D PREPARING THE FABRIC

PREPARING THE FABRIC
198
PREPARING THE FABRIC
Attaching Iron-on Stabilizers
(Backing) to the Fabric
For best results in your embroidery projects,
always use stabilizer material for embroidery.
Follow the package instructions for the stabilizer
being used.
Press o o o
o in this order to display a
video example of attaching iron-on stabilizers
(backing) to the fabric (see page 34). Follow the
steps explained below to complete the operation.
When using fabrics that cannot be ironed (such as
towel or fabrics that have loops which expand
when ironed) or in places where ironing is
difficult, position the stabilizer material under the
fabric without fusing it, then position the fabric
and stabilizer in the embroidery frame, or check
with your authorized dealer for the correct
stabilizer to use.
a
Use a piece of stabilizer which is larger
than the embroidery frame being used.
aSize of the embroidery frame
bIron-on stabilizer (backing)
CAUTION
• Use fabrics with a thickness of less than 3 mm (approx. 1/8 inch). Using fabrics thicker than 3 mm
(approx. 1/8 inch) may cause the needle to break.
• When using layers with thicker batting etc., you can sew more attractive embroidery by adjusting the
embroidery presser foot height in the embroidery settings screen (see below).
• In the case of thick terry cloth towels we recommend that you place a piece of water soluble stabilizer on
the top surface of the towel. This will help to reduce t he nap of the toweling and result in more attractive
embroidery.
Note
• Press , and selec t page 6/7 to use and in the Embroidery Foot Height display in the
embroidery settings screen. Adjust the presser foot height fo r thick or puffy fabrics.
• To increase the space between the presser foot and the needle plate, set the embroidery foot height to
a larger number, 1.5mm setting is used for most embroidery.
CAUTION
• Always use a stabilizer material for
embroidery when sewing stretch fabrics,
lightweight fabrics, fabrics with a coarse
weave, or fabrics which cause pattern
shrinkage. Otherwise, the needle may break
and cause injury. Not using a stabilizer
material may result in a poor finish to your
project.