MAKING EMBROIDERY ADJUSTMENTS
Embroidery
229
5

■Bobbin Thread is Too Loose

Bobbin thread appears slightly on the right side of
fabric.
aRight side
bWrong side
If this occurs, turn the slotted screw (-) clockwise,
being careful not to over-tighten the screw,
approximately 30-45 degrees to increase bobbin
tension.

■Bobbin Thread is Too Tight

Upper thread on the right side of fabric seems to be
lifting/looping and bobbin thread is not seen on the
wrong side of fabric.
aRight side
bWrong side
If this occurs, turn the slotted screw (-)
counterclockwise, being careful not to over-loosen
the screw, approximately 30-45 degrees to decrease
bobbin tension.
Using the Automatic Thread Cutting Function (END COLOR TRIM)

The automatic thread cutting function will

cut the thread at the end of sewing each color.

This function is initially turned on. To turn this

function off, press key and then . This

function can be turned on or off during

embroidering.

* This setting returns to its default
when the machine is turned off.
a
Press .
b

Press to turn off the automatic thread

cutting function.

oThe key will display as
* When one color thread is sewn, the machine will
stop without cutting the thread.
• When adjusting the alternate bobb in case, be
sure to remove the bobbin from the alternate
bobbin case.
• DO NOT adjust the position of the phill ips (+)
screw on the alternate bobbin case as this may
result in damage to the bobbin case, rendering
it unusable.
• If the slotted screw (-) is difficult to turn, do
not use force. Turning the screw too much or
providing force in either (rotational) direction
may cause damage to the bobbin case. Should
damage occur, the bobbin case may not
maintain proper tension.